Arctic Cat Panther 1974 Manual page 134

DRIVE CLUTCH DISASSEMBL V
5. Push the spider assembly down against the
moveable sheave, Fig. V-9 .
II
Note: The spider assembly may tend to stick
on the hex shaft even after the set screws are
loosened and downward pressure is exerted. If this
situation occurs, the spider assembly is to be
forced down on the hex shaft.
Fig. V-9
6. Slide the split ring halves out of the groove in
the hex shaft, Fig. V -10_
Fig. V-10
V·18
7. Mark the spider assembly in relation to the
hex shaft so that it can be installed in the
same position. Slide spider assembly off hex
shaft, Fig. V-11.
Fig. V-ll
8. Slide moveable sheave off hex shaft, Fig_
V-12_
Fig. V-12
9. If the spider, rollers and/or weights are to be
serviced, use the following instructions:
A. Remove locknut and capscrew that
secures weights and roller with bushing
to the roller arm, using a 3/8-inch
wrench, Fig. V-13.
B. Slide roller with bushing from between
roller arm, Fig. V-13.
II
Note: There are 2 small "ears" that protrude
on the inside of the roller arm. These ears
must be taken into consideration when roller with
bushing is being removed.
C. Perform steps A and B on remaining
roller arms.
)
)