Steering Servicing; Remove Throttle Control Handle - Arctic Cat Panther 1974 Manual

STEERING SERVICING
Remove Throttle Control Handle
Equipment Necessary: Screwdriver Having a
1/4-lnch Blade, Screwdriver Having a 3/16-lnch
Blade, 1/4 x 3/32-lnch Flat End Punch, Hammer,
5/16 x 1/8-lnch Flat End Punch and 1/8-lnch
Allen Wrench
1. Remove the protective pad from the
handlebar.
2. Loosen the screw holding throttle cable to
carburetor-mounted throttle arm, using a
screwdriver having a 1/ 4-inch blade.
3. Remove the retaining ring from the pin, Fig.
VII -l, that holds throttle lever to throttle
handle, using a screwdriver having a l/4-inch
blade.
Fig. VII·'
4. Remove the pin that holds throttle lever to
throttle handle; then disconnect end of
throttle cable from "seat" in throttle lever,
Fig. VII -2.
5. Remove the two machine sc rews, Fig . VII-2,
that hold emergency kill switch in the throttle
handle mounting socket, using a screwdriver
having a 3/ 16-inch blade.
Fig. VII·2
Machine
Screws
VII·2
Throttle Cable
and Seat
6. Remove spring pin, Fig. VI I-3, that holds the
throttle safety switch in the throttle handle,
using a 1/ 4 x 3/ 32-inch flat end punch and
hammer.
Fig. VII ·3
7. Pull throttle safety switch out of th rottle
hand le, Fig. VilA. Emergency kill switch and
throttle safety switch should now be free of
the throttle handle. MAKE SURE THAT
THROTTLE SAFETY SWITCH CASINGS
DO NOT PULL APART.
8. Remove the spring pin, Fig. VII-4, that holds
throttle handle on handlebar, using a 5/ 16 x
1/ 8-inch flat end punch and hammer.
Fig. VII-4
Emergency
Kill Switch
"
Spring
Throttle
Safety Switch
9. Remove the set screw that holds throttle
handle on handlebar, using a 1I8-inch allen
wrench. Pull throttle handle off handlebar.