Arctic Cat Panther 1974 Manual page 74

CARBURETOR SERVICING (ASSEMBLY)
16. Place the circuit plate gasket, circuit dia-
phragm and the circuit plate in position on
the bottom of the carburetor body, Fig.
111-21. Secure components in place with 3
screws, using a screwdriver.
Fig. 111 -21
17. Insert the metering lever spring into the spring
seat, Fig. 111 -22.
18. Slide the metering lever pin, Fig. 111-22,
through the holes in the metering lever.
19.
Position the inlet needle, Fig.
111 -22,
on the
end of the metering lever.
Fig. 111 -22
Metering
Lever Spring .... "
111-14
ng
Lever
YJ
in
I
Inl.t ·
Needle
I
20. Place dimple in metering lever over the
metering lever spring and ensure the inlet
needle slides down into the inlet needle seat.
Hold components in place and secure to the
carburetor body with the retaining screw, Fig.
111-23.
Fig. 111·23
21. Set the metering lever to 0.005 - 0.020 inch
above the sides of the carburetor body (see
Adjust Metering Lever, steps 3, 4, 5 and 6,
page
111-15).
22. Place the metering diaphragm on the carbure-
tor body, Fig.
111-24.
II
Note: The half dollar sized metal washer in
the metering diaphragm is to be positioned
against the carburetor body.
Fig. 111-24
Carburetor
Body
Metering
Diaphragm
I