Remove Hood, Headlight, Hinge Bracket And Hinge Support - Arctic Cat Panther 1974 Manual

r
(
(
BODY SERVICING
Fig. VII-92
5. Pull the recoil handle and bracket into
position on the side of the lower shroud.
Secure recoil bracket to lower shroud with
two machine screws, flat washers and lock
nuts, using a 7/16-inch wrench and a
screwdriver having a 7/16-inch blade.
6. I nstall the toolbox door by placing both
hands behind the door and thumbs around
the sides. Exert pressure toward center of
door and push it downward into the lower
shroud mounting curve when door is bowed
far enough, Fig . VII-93.
Fig. VII-93
7. Install the instrument panel (see Install Instru-
ment Panel, page VII-26).
Remove Hood, Headlight, Hinge Bracket and Hinge
Support
Equipment Necessary: Screwdriver Having a
1/4-1
nch Blade, Pliers, 7/16-lnch Socket,
Screwdriver Having a 7/16-lnch Blade, 1/4-lnch
Wrench, Phillips Screwdriver Having a No_ 1 Blade
and Phillips Screwdriver Having a No.3 Blade
1. Remove the hood cable from the hood by
prying looped end over rivet, using a
screwdriver havi ng a
11
4-i nch blade.
2. Disconnect the headlight harness from the
main wiring harness.
3. Remove the push nut, Fig. VII-94, from the
pins that hold hood to hinge support, using a
pliers. After push nuts are removed, pull pins
out of hood hinge and hinge support, Fig.
VII-94, using a pliers.
Fig. VII-94
VII-29