Driven Pulley Removal - Arctic Cat Panther 1974 Manual

CLUTCH'PULLEY PARALLELISM ADJ.
Parallelism Adjustment
Equipment Necessary: 9/16-lnch Socket, 12-lnch
Extension and 3-lnch Extension
1. Remove the locknut that holds left rear
motor mount as viewed from the operator's
position, using a 9/16-inch socket and 3-inch
extension . Also loosen the locknuf that holds
the right rear motor mount.
2. Loosen the locknuts holding front of motor
plate, using 9/16-inch socket and 12-inch
extension.
3. Insert a shim between the bottom of the left
rear motor mount and the curved section of
the front end assembly.
4. Tighten all locknuts and check parallelism and
offset (see Drive Clutch/Driven Pulley
Alignment, page V-24l.
II
Note: Continue to add shims until parallelism
is obtained.
DRIVEN PULLEY REMOVAL
Remove Brake Cable, Clutch Shield and Drive Belt
Equipment Necessary: 1/2-lnch Open End Wrench,
7/16-lnch Open End Wrench and 7/16-lnch Socket
1. Loosen brake cable flange nuts, Fig. V -26,
using a 1/2-inch wrench.
2. Remove capscrew and locknut that holds end
of brake cable to brake arm, Fig. V-26, using
a 7/16-inch wrench and socket. Pull brake
cable through clutch shield and move cable to
the side.
Fig. V·26
3. Remove two front locknuts, Fig. V-27, that
hold clutch shield to weld studs, using a
7/16-inch socket.
V-26
Fig. V·27
4. Remove two rear locknuts, Fig. V-28, that
hold clutch shield to weld studs, using a
7/16-inch open end wrench.
5. Remove clutch shield and set aside.
Fig. V·28
J