Arctic Cat Panther 1974 Manual page 195

STEERING SERVICING
I nstall Throttle Control Handle
Equipment Necessary: Hammer, 1/8-lnch Allen
Wrench, 1/4 x 3/32-lnch Flat End Punch, Hammer,
Screwdriver Having a 3/16-lnch Blade and
Screwdriver Having a 1/4-1 nch Blade
1. Slide the throttle handle on the handlebar,
making sure that socket for emergency kill
switch is toward the rear of the snowmobile.
Move throttle handle into position desired,
then secure in place with sp ring pin, Fig.
VI I-5, using a hammer. Tighten set screw,
using a 1/S-inch allen wrench.
Fig. VII-5
Spring
Pin
Move throttle safety switch and throttle cable
into position on the throttle handle. Secure
switch to throttle handle with sp ring pin,
using a 1/4 x 3/ 32-inch flat end punch and
hammer, Fig. VII-6.
Fig. VII-6
3. Move the emergency kill switch into position
in the throttle handle switch socket and
secure It
In
place with two machine screws,
Fig. VII-7, using a screwdriver having a
3 / 16 -inch blade. DO NOT TIGHTEN
MACHINE SCREWS EXC ESS IVELY.
4. Hook end of throttle cable into throttle lever
seat, Fig. VII-7 .
Fig. VII-7
Machine
Screws
Throttle Cable
and Seat
5. I nstall throttle lever and "seated" throttle
cable on the throttle handle with pin and
retaining ring, Fig. VII-S.
Fig. VII-8
6.
Pin and
Retaining Ring
l
I nstall end of throttle cable In the
ca rburetor-mounted throttle arm . Pull end of
throttle cable until slack is removed; then pull
cable an additional 1/16-inch to preload the
th rottl e safety switch spring. T ighten
retaining screw, using a screwdriver having a
1/4-inch blade.
II
Note: The desired adjustment is wh en the
handle-mounted throttle lever lightly contacts
the throttle handle and the carburetor throttle
plate is fully open.
7. Install protective pad on the handlebar.
VII-3