Remove Rotor And Rotor Housing; Remove Mainshaft - Arctic Cat Panther 1974 Manual

ENGINE SERVICING (DISASSEMBLY)
Fig. 11·23
2.
Carefully lift the PTO end cover off the rotor
housing and mainshaft.
II Note: As the end cover is removed, the dowel
sleeves, rotor sealing pins, sealing pin springs,
side seals and side seal springs, Fig. 11 -24, may stick
to the end cover. Exercise care so that these
components do not accidentally fall, and as a
result, become lost.
e
CAUTION
e
Protect the end cover sliding surface and the
bearing contained within the end cover from
dirt and accidental damage.
Fig. 11-24
Remove Rotor and Rotor Housing
Equipment Necessary: No Special Tools Required
1. Remove the rotor from the rotor housing and
mainshaft, exercising care so that the rotor is
not accidentally dropped and damaged, Fig.
11-24.
The apex seals, apex seal springs, side
seals, side seal springs, sealing pins and sealing
pin springs may stick to the PTO end cover
when the rotor is removed. Parts to be
accounted for are 3 apex seals and springs,
6 side seals and springs, 6 sealing pins and 12
sealing pin springs.
II
Note: Place rotor and sealing components on
a clean area where accidental damage will not
occur.
2 . Lift the rotor housing off the magneto end
cover. Account for the 2 dowel pins.
CAUTION
Protect both
PTO
and magneto end covers and
the rotor housing from damage. Accidental
damage will require replacement of component
prior to assembly.
Remove Mainshaft
Equipment Necessary: Center Punch, Conventional
Hammer, Self-Tapping Screw, Wire Pinchers, Snap
Ring Pliers and Rubber Hammer
The mainshaft is not to be removed from the
magneto end cover unless repair of the mainshaft,
pinion gear, end cover, bearing or rotor is
necessary.
1. Punch a hole into the magneto end cover seal
and thread a self-tapping screw into the hole.
Pull out oil seal by grasping the screw, using a
pinchers, Fig.
11-25.
Fig. 11-25
11·15