Arctic Cat Panther 1974 Manual page 200

STEERING SERVICING
2. Slide brake cable into position in brake
handle and hook end of brake cable into the
brake lever.
3. Install brake lever and seated brake cable on
the brake handle with the pin and retaining
ring, Fig. VII-26 .
Fig. VII·26
4. Slide the brake switch into the brake handle
making sure that recess in side of switch will
match with the spring pin.
5. Squeeze the brake lever fully and move switch
so that flat end of switch casing is flush with
the brake lever stop. Drive sprirg pin
downward until the end is flush with dimmer
switch socket, Fig. VII -27, using 1/ 4 x
3/32-inch flat end punch and hammer. Brake
switch should now be retained in the brake
handle.
Fig. VII -27
Spring
Pin
Brake
(~ ~ O
I
~
,<4
-- ;. -0
I \
",
".- :.
-'.
Recess Brake
Switch
6. Move the dimmer switch into position in the
brake handle switch socket and secure in
place with two machine screws, Fig . VII-28,
VII -8
using a screwdriver having a 3/ 16-inch blade.
DO NOT TIGHTEN MACHINE SCREWS
EXCESSIVEL Y.
7. Install protective pad on handlebar.
Fig. VII ·28
Remove Brake/Djmmer Switch
Equipment Necessary: Screwdriver Having a
3/16-lnch Blade, 1/8-lnch Allen Wrench, 1/4 x
3/32-1 nch Flat End Punch a'nd Hammer
1. Remove the protective pad from the
handlebar.
2. Remove the two machine screws, Fig. VII-29,
that hold d immer switch in the brake handle
mounting socket, using a screwdriver having a
3/ 16-inch blade.
3. Loosen the set screw, Fig. V 11-29, that holds
brake handle, using a 1I8-inch al len wrench.
Fig. VII-29
Machine
4. Rotate brake handle until brake lever faces
toward rear of the machine; then tighten the
set screw, using a lIB-inch allen wrench.
5. Drive the spring pin that holds brake sw itch
inward approximately 1/ 2-inch, using a 1/ 4 x
3/ 32-inch flat end punch and hammer, Fig.
VII-30.
)
.J