Arctic Cat Panther 1974 Manual page 138

DRIVE CLUTCH ASSEMBL V
II
A.
Slide bushing into roller and install both
components between the roller arm, Fig.
V-17, making sure the bushing "cut
outs" slide over the 2 small "ears" on
the inside surface of the roller arm.
B. Slide a weight onto the capscrew and
push capscrew through roller arm, roller
and bushing.
Note: Head of capscrew is to be positioned on
side of roller arm having the 2 small "ears".
C. SI ide another weight onto opposite end
of capscrew and secure with locknut.
Tighten locknut to 3-4 ft. Ibs. torque,
using a 3/ 8-inch socket, 3/ 8-inch wrench
and a torque wrench.
D. Perform steps A, Band C on remaining
rollers, bushings and weights, Fig. V-17.
Fig. V-17
E. Install the 3 setscrews with locknuts in
the spider assembly. End of set screws is
not to extend into center area of spider.
5. Slide the complete spider assembly onto the
hex shaft in the same position occupied
before disassembly, Fig. V-18. Side of spider
with stamped part number is to face up. .
II Note: During disassembly the spider was to
have been marked in relation to the hex shaft.
This marking enables same position installation.
V-22
Fig. V·18
6. I nstall the split ring halves In the hex shaft
groove, Fig. V-19.
Fig. V·19
7. Pull the spider assembly up against the split
ring halves. Tighten set screws to 3-4 ft. Ibs.
torque, using a 3/ l6-inch socket and torque
wrench. Bottom the locknuts against the
spider, Fig. V -20, to lock the set screws in
place, using a 3/ 8-inch wrench.
)
_ Note: End of set screws is to slide into the '\
- recess in the hex shaft to ensure proper spider
J
retention.