Install Brake/Dimmer Switch - Arctic Cat Panther 1974 Manual

STEERING SERVICING
Fig. VII -34
To Brake
Switch
o
10. Remove the brake/ dimmer switch wires from
the connectors, using a screwdriver having a
3/ 16-i nch blade.
II Note: Connectors are removed from brake
and dimmer switch wires so that complete
harness can be pulled through upper steering post
bracket and clamp. If connectors are allowed to
remain on harness, you will not be able to pull the
harness through upper steering post bracket and
clamp_
11 . Pull brake/ dimmer switch harness through
upper steering post bracket, clamp and
instrument panel.
Install Brake/Dimmer Switch
Equipment Necessary: 1IS-lnch Allen Wrench, 1/4
x 3/32-lnch Flat End Punch, Hammer and
Screwdriver Having a 3/16-lnch Blade
1. Slide end of brake/dimmer switch harness
through instrument panel, upper steering post
bracket and clamp.
2. Install connector on end of long single black
wire that runs to the dimmer switch.
3. Install T-shaped connector on end of black
wire and black wire with white tracer that
runs to the dimmer switch, Fig. VII -35 .
VII -l0
Fig. VII-35
White
Black
To Dimmer
Switch
Black/White Tracer
4. Install Z-shaped connector on end of black
wire and black wire with white tracer that
runs to the brake switch, Fig. VII -36.
Fig. VII-36
Red
To Brake
Switch
o
Black/White Tracer
o
To Taill ights/Brakelights
o
To Light Switch
Red
5. Connect the single black wire that runs from
the dimmer switch to the lower right
vertically-oriented termi nal on the light
switch, Fig _ VII-37.
)
)