Arctic Cat Panther 1974 Manual page 146

DRIVEN PULLEY DISASSEMBLY
Fig. V·38
c. )
4. Slide cam bracket and spring off stationary
sheave hub, Fig. V-39. Remove cam bracket
sliding shoes, Fig. V-39, if servicing is
required, using a pliers.
II Note: If cam bracket is hard to remove, a
three-pronged puller can be used to pull cam
bracket off hub.
Fig. V-39
5. Remove woodruff key from keyway, using a
side cutter or pliers, Fig. V -40.
V·3D
Fig. V-40
6. Slide moveable sheave off stationary sheave
hub, Fig. VAl. Driven pulley is completely
disassembled at this time.
Fig. V-41
7.
Clean and inspect driven pulley (see Cleaning
and Inspecting, page V-33).
Disassemble Eccentric Bearing and Shaft - If
Required
Equ ipment Necessary: 1/8-1 nch Allen Wrench,
Rag, 5/16 x 1/8-lnch Flat End Punch, 3/32-lnch
Allen Wrench, Hammer, Propane Torch and Two
1-lnch Thick Wooden Blocks
1. Loosen lock collar set screw, using a 1/ 8-inch
Allen wrench, Fig. V-42.
Fig. V-42
)
)