Arctic Cat Panther 1974 Manual page 54

ENGINE INSTALLATION
10. Adjust the throttle control (see Section III -
Fuel System, Throttle Adjustment).
11. Tip the snowmobile on its side and use a piece
of cardboard or similar material to prevent
scratch ing.
12. Secure the motor mounts to the belly pan
with 2 locknuts, using a 9/16-inch socket and
an 8-inch extension. Tighten the locknuts to
35 ft. Ibs. torque, using a torque wrench. Tip
the snowmobile right side up.
Fig. II-59
--
~ -
--
-.
_.
----
Motor
Mount
11-30
\J
_. ---
-----,..L~
Track
13. Install the hood with 2 pins and retain in
place with 2 push nuts.
14. Push the headlight harness connector into the
headlight connector block.
15. Secure the hood cable to the inside of the
front end assembly and belly pan with a
phillips screw, flat washer and locknut, using
a phillips screwdriver and 1/2-inch wrench.
16. Check the center to center distance between
the drive clutch and driven pulley (see Section
V - Drive System, Center to Center Dis-
tance) .
17. Check the offset between the drive clutch and
driven pulley (see Section V - Drive System,
Offset).
18. Install the drive belt (see Section V - Drive
System, Install Drive Belt) _