Remove Throttle Safety/Kill Switch - Arctic Cat Panther 1974 Manual

STEERING SERVICING
Remove Throttle Safety/Kill Switch
Equipment Necessary: Screwdriver Having a
1/4-lnch Blade, Screwdriver Having a 3/16-lnch
Blade, 1/4 x 3/32-lnch Flat End Punch and
Hammer
1. Remove the protective pad from the
handlebar.
2. Loosen the screw holding throttle cable to
carburetor-mounted throttle arm, using a
screwdriver having a 1/4-inch blade.
3. Remove the retaining ring from the pin, Fig.
VII-9, that holds throttle lever to throttle
handle, using a screwdriver having a 1/4-inch
. blade.
Fig. VI/·9
4. Pull out pin that holds throttle lever to
throttle handle; then disconnect end of
throttle cable from "seat" in throttle lever,
Fig. VII -10.
5. Remove the two machine screws, Fig. VII-10,
that hold emergency kill switch in throttle
handle mounting socket, using a screwdriver
having a 3/16-inch blade.
Fig. VI/·10
V 11-4
Machine
Screws
Throttle Cable
and Seat
6. Remove spring pin, Fig. VII-11, that holds )
throttle safety switch in the throttle handle,
using a 1/4 x 3/32-inch flat end punch and
hammer.
Fig. VII·ll
7. Pull throttle safety switch out of throttle
handle, Fig. VII-12. Emergency kill switch
and throttle safety switch should now be free
of the throttle handle.
Fig. VI/ · 12
Emergency
~KiliSwitch
:'-.
Throttle Safety
Switch
8. Slide the throttle safety switch cover off the
switch holder and account for the locking tab,
Fig. VII -13.
Fig. VI/·13
)