Arctic Cat Panther 1974 Manual page 83

ADDENDUM NO.1
r
Fuel Pump Pumping Pressure
Equipment Necessary: Plastic "T" Fitting and Pressure Gauge
1. I nstall the plastic
liT"
fitting and pressure gauge in the fuel I ine that feeds the carburetor, Fig.
111-44.
2. Raise the rear of the snowmobile off the shop floor, using a Quik Jack. Make sure the track is free
to rotate.
3. Start the engine. Between 2000-6000 RPM, pumping pressure is to remain at approximately 3.5 Ibs.
If pressure is not 3.5 Ibs., but is greater (approximately 10-15 Ibs.), the fuel pump is defective and is
to be replaced.
Fig. 111·44
From Fuel Tank
To Carb
Section
III
©
Arctic Enterprises, Inc. 1974
Form No. 0153·030