Remove Lower Shroud (Toolbox) - Arctic Cat Panther 1974 Manual

c
-
c
BODY SERVICING
4. Slide the complete choke control assembly
through the instrument panel and lock it in
place, Fig. VII-87. Move the
carburetor-mounted choke arm fully forward
(toward engine) and install choke wire.
Position the front edge of the
console-m ounted choke knob 1I8-inch away
from the choke "stop". When knob is in
proper position, tighten choke wire retaining
screw, using a screwdriver having a 1/ 4-inch
blade.
Fig. VII·87
5. USE THIS STEP ONLY IF ENGINE IS
EQUIPPED WITH A DIAPHRAGM-TYPE
CARBURETOR - Install air intake hose to
the right side of the instrument panel with the
nylon strap, machine screw and lock nut, Fig.
VII -88, using a 7/ 16-inch wrench and a
screwdriver having a 5/ 16-inch blade.
Fig. VII·88
6. Connect electrical wires and cables for
speedometer, tachometer and heat gauges, if
the snowmobile is so equipped.
Remove Lower Shroud (Toolbox)
Equ i pment Necessary: 7/16-lnch Wrench,
Screwdriver Having a 7/16-1 nch Blade, Air-Powered
Drill and 5/32-1 nch Bit
1. Open the toolbox door completely. Place
both hands behind the door and thumbs
around the sides. Exert pressure toward
center of door and pull upward when door is
bowed far enough to release it from mounting
curve in lower shroud, Fig. VII-89. .
Fig. VII·89
2. Remove the instrument panel (see Remove
I nstrument Panel, page VII-25).
II Note: It is not necessary to remove the light
switch and complete choke assembly from the
instrument panel when lower shroud is to be
removed.
3. Remove the two machine screws, flat washers
and lock nuts that hold the recoil bracket to
the side of the lower shroud, using a
7/ 16-inch wrench and a screwdriver having a
7/16-inch blade. Before the machine screws
are removed, grasp recoil handle to prevent a
sudden rewind; then pullout machine screws
and allow the recoil handle to rewind against
the recoil housing.
4. Remove the seat from the tunnel.
VII-27