Arctic Cat Panther 1974 Manual page 207

c
c
c
STEERING SERVICING
Fig. VII·50
7. Install the instrument panel on the lower
shroud with the three-quarter-turn studs,
using a screwdriver having a 7/16-inch blade.
8. Connect the wires to the light switch
terminals. Make sure that vertically-oriented
terminals are nearest to the steering post. If
terminals are not in this position, remove the
light switch and install properly.
A. Connect the TWO B LACK wires that are
contained in one plug to the upper right
vertically-oriented terminal, Fig. VII-53.
One of the black wires runs to the
taillights, the other to the circuit board
"L I G HTS".
B. Connect the long BLACK wire that runs
from the dimmer switch to the lower
right vertically-oriented terminal, Fig.
VII-53.
C. Connect the RED wire that runs from
the brake switch to the top left
horizontally-oriented terminal, Fig.
VII-53.
D. Connect the YE LLOW wire that runs
from the ignition switch to the lower left
horizontally-oriented terminal, Fig.
VII-53.
Fig. VII·53
Wire
Two
Black
Wire
9. Slide the ignition switch through the
instrument panel; then secure in place with
the ring nut, Fig. VII-54 . DO NOT
OVER-TIGHTEN RING NUT.
II Note: It is possible to install the ignition
switch upside down. Make sure single prong
terminal on ignition switch is toward the steering
post.
Fig. VII·54
VII-15