Install Throttle Safety/Kill Switch - Arctic Cat Panther 1974 Manual

c
(
STEERING SERVICING
9.
Disengage end of throttle cable from the
throttle cable switch block, Fig. VII -1 4. Pull
throttle cable out of the throttle safety switch
cover.
Fig. VII-14
Throttle Cable End
10. Disconnect the square connector at end of kill
switch harness from connector that holds the
two black wires running to the "G" and "M"
terminals on the ignition switch, Fig. VII-15.
11. Remove the kill switch wires from the
connector, using a screwdriver having a
1/ 4-inch blade.
II
Note: Connector is removed from end of kill
switch harness so that complete harness can
be pulled through upper steering post bracket and
clamp. If connector is allowed to remain on
harness, you will not be able to pull the harness
through upper steering post bracket and clamp.
12. Pull throttle safety/kill switch harness
through upper steering post bracket, clamp
and i nstru ment panel.
Install Throttle Safety/Kill Switch
Equipment Necessary: 1/4
x
3/32-lnch Flat End
Punch, Hammer, Screwdriver Having a 3/16-lnch ·
Blade and Screwdriver Having a 1/4-lnch Blade
1. Slide end of kill switch harness through
instrument panel, upper steering post bracket
and clamp.
2. I nstall the kill switch wires in the square
connecto r, Fig. VII -15. Push together the kill
switch wire connector and connector that
holds the two black wires running to the
"G"
and "M" terminals on the ignition switch, Fig.
VII -1 5.
Fig. VII·15
To Emergency
Brown
0
Kill Switch
~'k/Y'''OW
T,,,,,
~
Black
~ ';'-<
'''
Ignition
/ Switch
.-'"
Black
3. Slide 'throttle cable through throttle safety
switch cover. Install end of throttle cable in
the switch block, Fig. V 11-16.
Fig. VII -16
4. Move black wire against switch casing; then
place locking tab (recess in tab over black
wire) in switch casing, Fig. VII-17. Push
throttle safety switch cover onto switch.
Make sure all components remain seated and
in place.
VII-S