Driven Pulley Disassembly - Arctic Cat Panther 1974 Manual

\
l . .
c
c
c
DRIVEN PULLEY REMOVAL
10. Grasp driven pulley and pullout eccentric
bearing w/shaft, Fig. V -36. Driven pulley and
eccentric shaft are to be apart at th is time.
Lay driven pulley and eccentric assembly
aside.
II Note: If eccentric bearing and/or shaft is to
be serviced, disassemble eccentric bearing
from shaft (see Disassemble Eccentric Bearing and
Shaft, page V-30). If driven pulley is to be serviced,
disassemble the driven pulley (see Disassemble
Driven Pulley, page V-29). It is not necessary to
disassemble the eccentric bearing and shaft if only
the driven pulley is to be serv iced.
Fig. V·36
DRIVEN PULLEY DISASSEMBLY
Disassemble Driven Pulley
Equipment Necessary: Screwdriver, Rubber Mallet,
Snap Ring Pliers and Side Cutter
1. SI ide screwdriver between cam bracket and
spring. Pry spring until all spring preload is
released.
2. Drive cam bracket toward moveable sheave
until side pressure is removed from snap ring,
Fig. V -37, using a rubber mallet.
Fig. V ·37
3. Remove snap ring from groove at end of
stationary sheave hub, Fig. V-38, using a snap
ring pliers.
V-29