Arctic Cat Panther 1974 Manual page 158

DRIVEN PULLEY INSTALLATION
e
CAUTION
e
Be sure chain case cover and gasket are installed
evenly and a good seal exists between chaincase
cover and backing plate. If, after filling chain-
case with chain lube and a leak develops due
to an improper seal, mechanical damage will
occur because of improper chain and sprocket
lubrication.
12. Fill chaincase with S ounces of Arctic chain
lube, Fig. V-7S. Chain lube is to be at the
point of overflowing in check plug hole, Fig.
V-7S. Install rubber filler plug and check plug.
13. I nstall drive belt, clutch sh ield and brake
cable (see I nstall Drive Belt, Clutch Shield and
Brake Cable, page V-42l.
Fig. V-l8
I nstall Drive Belt, Clutch Shield and Brake Cable
Equipment Necessary: 7/16-lnch Socket,
7/16-lnch Open End Wrench and 1/2-lnch Open
End Wrench
1. Install drive belt, Fig. V-79.
2. Place clutch shield in position on front and
rear weld studs.
V-42
Fig. V-l9
3. Retain front of clutch shield to weld studs
with 2 locknuts, Fig. V -SO, using a 7/16-inch
socket.
Fig. V-80
4. Retain rear of clutch shield to weld studs with
2 locknuts, Fig. V-S1, using a 7/16-inch open
end wrench.
Fig. V-81
)
J