Arctic Cat Panther 1974 Manual page 148

DRIVEN PULLEY DISASSEMBLY
Fig. V-46
10.
After bearing is removed, inspect the inside of
the eccentric housing and the bearing for wear
and damage. Bearing is to have generous
supply of grease, Fig. V-47.
Fig. V-47
V-32
11. Place the eccentric housing on two 1-inch
thick wooden blocks ("0" ring groove side
down). Heat the area from the "0" ring
groove down, using a propane torch.
12. Drive the bearing out of the eccentric
housi ng, usi ng a 5/16 x lIB-i nch . flat end
punch and hammer, Fig. V-4B.
Fig. V-48
13. After the bearing is removed, inspect the
inside of the eccentric housing and bearing for
wear and damage.
I
)