Arctic Cat Panther 1974 Manual page 69

CARBURETOR SERVICING (DISASSEMBLY)
Fig. 111·8
9 . Remove the idle adjusting screw and spring,
using a screwdriver, Fig. II 1-9. Separate idle
adjusting screw and spring.
Fig. 111·9
10. Remove the screw and star washer, Fig.
II 1-1 0, that secu res the choke butterfly to the
choke shaft, usi ng a screwdriver. Pull choke
butterfly, Fig. III-10, from between
the split
section of the choke shaft.
Fig. 111-10
11. Hold intake side of carburetor upward and
pull the choke shaft from within the
carburetor body, Fig. II 1-11. Carefully tip
carburetor over and allow the choke shaft
friction ball and spring to fall from the hole,
Fig. 111-11, in the carburetor body into a
cupped hand.
Fig. 111 -11
12. Remove the screw and star washer, Fig.
111-12, that secu res throttle butterfly to the
throttle shaft, using a screwdriver. Pull throt-
tle butterfly, Fig. 111-12, from between the
split section of the throttle shaft.
Fig. 111-12
13. Push the retaining ring, Fig. 111-13, off the
end of the throttle shaft, using a screwdriver.
14.
Slowly allow the throttle return spring to
release all tension and pull the throttle shaft
and spring from within the carburetor body.
II
Note: DO NOT lose the nylon bushing
located on the spring end of the throttle
shaft.
11/-9