Arctic Cat Panther 1974 Manual page 155

c
c
DRIVEN PULLEY INSTALLATION
Fig. V ·6S
19. Remove rubber filler plug and check plug
from chaincase cover. Install chaincase cover
and gasket to backing plate with 3 thumb
screws and washers, Fig. V-69.
20. Fill chaincase with 8 ounces of Arctic chain
lube, Fig. V-69. Chain lube is to be at point of
overflowing in check plug hole, Fig. V-69.
install rubber filler plug and check plug.
Fig. V-69
e
CAUTION
e
Be sure chaincase cover and gasket is installed
evenly and a good seal exists between chaincase
cover and backing plate. If, after filling
dropcase with chain lube and a leak develops
due to an improper seal, mechanical damage
will occur because of improper chain and
sprocket lubrication.
21. Install drive belt, clutch shield and brake
cable (see Install Drive Belt, Clutch Shield
and Brake Cable, page V-42).
I nstall Driven Pu lIey
W/Lock Collars
Eccentric Assembled
II
Note: Use this set of instructions ONLY if
eccentric bearing and shaft WAS NOT
disassembled. If eccentric bearing and shaft WAS
disassembled, use preceding set of instructions (see
I nstall Driven Pulley - Eccentric Disassembled,
page V-34l.
Equipment Necessary: 5/16 x 1/8-lnch Flat End
Punch, Hammer, 1/2-lnch Socket, Torque Wrench,
12-lnch Straight Edge, Steel Ruler and Arctic
Chain Lube
1. Hold driven pulley on inside of eccentric
mount, then sl ide eccentric shaft (keyway
end) into mount and through driven pulley,
Fig. V-70.
II Note: Threaded holes in eccentric bearing are
to be exposed in eccentric mount slide area.
Fig. V-70
V-39