Remove Outside Tie Rod End And Tie Rod - Arctic Cat Panther 1974 Manual

STEERING SERVICING
10. USE THIS STEP ONLY IF ENGINE IS
EQUIPPED WITH A DIAPHRAGM-TYPE
CARBURETOR - Install air intake hose to
the right side of the instrument panel with the
nylon strap, machine screw and lock nut, Fig.
VII-51, using a 7/16-inch wrench and a
screwdriver having a 5/16-inch blade.
Fig. VII-51
11. Move the carburetor-mounted choke arm
fully forward (toward engine) and install
choke wire, Fig. VII-52. Position the front
edge of the console-mounted choke knob
1I8-inch away from the choke "stop". When
knob is in proper position, tighten choke wire
retaining screw, Fig. VII-52, using a
screwdriver having a 1 /4-inch blade.
VII-16
Fig. VII-52
12. Connect electrical wires and cables for
speedometer, tachometer and heat gauges, if
the snowmobile is so equipped.
13. I nstall protective pad on handlebar.
14. I nstall tie rods (see I nstall Tie Rod and
Outside Tie Rod Ends, page VII -l7).
Remove Outside Tie Rod End and Tie Rod
Equipment Necessary: 9/16-lnch Open End
Wrench and 9/16-lnch Socket
1. Loosen the jam nut that locks tie rod end in
place, Fig. VII-55, using a 9/16-inch open end
wrench.
2. Remove the cap screw and lock nut, Fig.
VII-55, that holds tie rod end to spindle arm,
using a 9/16-inch socket and open end
wrench_
Fig. VII-55
)