Arctic Cat Panther 1974 Manual page 139

c
c
DRIVE CLUTCH ASSEMBL V
Fig. V -20
8. Slide the spring over the hex shaft, Fig. V-21.
9. Place the cover housing on the spring and line
up the alignment mark with those in the
moveable and stationary sheave, Fig. V -21 .
Fig. V-21
10. Compress (push down) the cover housing on
the hex shaft and lift up on the moveable
sheave until both components contact each
other, using the clutch puller bolt and large
flat washer. Secure the cover housing to the
moveable sheave, Fig. V-22, with 3 socket
head capscrews, usi ng a 1
I
4-i nch A lien
wrench. Tighten the capscrews to 15-17 ft.
Ibs. torque, using a 1/ 4-inch Allen wrench and
torque wrench.
Fig. V-22
V-23