Arctic Cat Panther 1974 Manual page 137

c
· MOVEABLE SHEAVE STAKING
2. If set screws are not 1/ 16-inch below casting
surface, tighten set screws unt il proper
measurement is evident, using a 3/ 32-inch
Allen wrench.
3. After set screws are tightened, the casting is
to be staked on the outside edge of each set
screw, using a 1/ 8-inch flat end punch and
hammer, Fig. V-15.
_ Note: When staking is performed, strike the
- punch with the hammer, using sufficient force
to deform the threads but not so hard as to break
off a part of the casting. This procedure will keep
the set screws in place and prevent them from
backing out.
Fig. V ·15
/
DRIVE CLUTCH ASSEMBL V
Assemble Drive Clutch
Equipment Necessary: 9/64-lnch Allen Wrench,
Torque Wrench, 3/8-lnch Socket, 3/8-lnch Wrench,
3/16-lnch Socket and 1/4-lnch Allen Wrench
1. Ensure all clutch components have been
cleaned, repaired or replaced.
2. Install ramp in moveable sheave and secure in
place with socket head capscrew, using a
9/ 64-inch Allen wrench. Tighten socket head
capscrew to 2-2.5 ft. Ibs. torque, using a
torque wrench. I nstall remaining ramps.
II
Note: A complete ramp kit is to be installed,
not an individual ramp. If new ramps are
being installed, new roller kit with bushings is to be
installed.
3. Slide the moveable sheave on the stationary
sheave hex shaft, Fig. V-16. The alignment
marks on both sheaves MUST line up to keep
the clutch balanced.
4. If the spider, rollers and / or weights were
serviced, use the following procedure:
II Note: A complete roller kit is to be installed,
not individual rollers. If new rollers are being
installed, a new ramp kit should have already been
installed (see Step 2). .
Fig. V·16
V-21