Cleaning Individual Components; Inspecting Individual Components - Arctic Cat Panther 1974 Manual

c
r
c
DRIVE CLUTCH DISASSEMBL V
II
Note: A complete roller kit with bushings is
to be installed, even if only 1 roller with
bushing is worn or damaged. New rollers with
bushings will have a definite "wear-in" pattern. If
rollers with bushings are to be replaced, new ramps
are to be installed (see step 10).
10. Remove the capscrews that secure the ramps
to the moveable sheave, using a 9/64-inch
Allen wrench. Slide ramp out of "ramp
setting" in moveable sheave.
II
Note: A complete ramp kit is to be installed,
even
if only 1 ramp is worn or damaged. If
ramps are to be replaced, new rollers with bushings
are to be installed.
Fig. V·13
CLEANING INDIVIDUAL COMPONENTS
Cleaning
Equipment Necessary: Cleaning Solvent and
Compressed Air
1. Wash grease, dirt and foreign matter off all
components, using cleaning solvent.
Dry
components with compressed air.
2. If drive belt accumulations are on the
stationary sheave, moveable sheave or the
moveable sheave Duralon bushing, the
accumulations are to be removed, using
cleaning solvent ON L Y. Dry components with
compressed air.
e
CAUTION
e
DO NOT use
steel wool or a wire brush on
components that have a Duralon bushing;
damage will result if contacted.
INSPECTING INDIVIDUAL COMPONENTS
Inspecting
Equipment Necessary: Cleaning Solvent and
Compressed Air
1. I nspect the stationary sheave, moveable
sheave and cover housing for cracks and
imperfections in the castings. Replace
component(s) as conditions dictate.
2. I nspect the spider for cracks and
imperfections in the casting. Arms, weights
and rollers with bush ings are to be without
damage or wear. Replace component(s) as
conditions dictate.
3. I nspect the ramp "settings" on the inside of
the moveable sheave for wear and cracks.
Replace the moveable sheave if ramp
"setting" is badly worn or damaged.
4. Inspect the spring for proper compression
qualities (see Spring Compression Test, page
V -20). If spri ng compression is not as speci-
fied or damage is evident, replacement is
necessary.
5. I nspect the ramps for wavy pattern that may
develop after usage. If ramp(s) is wavy,
replat:e as a complete set.
6. I nspect all threaded components for stripped
or otherwise damaged threads. Replace any
component(s) that is damaged.
V-19