Arctic Cat Panther 1974 Manual page 154

DRIVEN PULLEY INSTALLATION
14. When proper adjustment is obtained, tighten
capscrew w/grease fitting and any remaining
lock capscrew(s), Fig. V-64, using a 9/16-inch
socket. Recheck chain tension and adjust if
necessary.
Fig. V-64
15. Push offset adjusting collar against eccentric
bearing, then drive collar forward. A 5/16 x
1/8-inch flat end punch and hammer is to
be used to drive the collar. Tighten adjusting
collar set screw, using a 3/32-inch Allen
wrench, Fig. V-65.
Fig. V-65
V-38
16. Align the drive clutch and driven pulley, using
the alignment bar, Fig. V-66, (see Drive
Clutch/Driven Pulley Alignment, page V-24).
Fig. V-66
II
Note: Be sure "offset" is not accidentally
changed when lock collar half is moved
against driven pulley.
Fig. V-67
J
18. Secure driven pulley to eccentric shaft with
capscrew and flat washer, Fig. V-68, using a
1/2-inch socket. Pull driven pulley against flat
washer, then push toward eccentric beari ng.
No movement is to be evident. If movement
occurred, remove capscrew and flat washer;
add shim(s) until movement is eliminated.
Install capscrew, flat washer and shim(s).
.J
Tighten capscrew to 20 ft. Ibs. torque, using a
torque wrench/and 1/2-inch socket.
J