Arctic Cat Panther 1974 Manual page 230

BODY SERVICING
11. I nstall the fuel line and filter, rubber plug and
elbow in hole at right side of fuel tank, as
viewed from ,behind the snowmobile, Fig.
VII-115.
12. Install the vapor return line (if carburetor is
so equipped), rubber plug and elbow in hole
at left side of fuel tank, as viewed from
behind the snowmobile, Fig. VII-115. Install
fuel tank gauge cap, Fig. VII-115.
Fig. VII-115
13. Tip the snowmobile onto its side, using a
piece of cardboard to protect against
scratching.
14. Move rear arm of skid frame into alignment
with hole in tunnel. Slide lock washer onto
cap screw and secure the rear arm to the
tunnel, Fig. VII-116, using a 9/16-inch socket
and 3-inch extension. DO NOT TIGHTEN
CAP SCREW - THREAD IN ONLY HALF
WAY.
VII-38
II
Note: Rear arm of skid frame may not line up
with hole in tunnel. To obtain proper
alignment of the rear arm and hole in tunnel,
release rear idler wheel tension; then drive rear arm
in proper direction until alignment is obtained,
using a hammer.
15. Tip snowmobile on opposite side, using a
piece of cardboard to protect against
scratch ing.
16. Slide lock washer onto cap screw and secure
rear arm to the tunnel, Fig. VII-116, using a
9/16-inch socket and 3-inch extension. Tip
snowmobile upright.
17. Tighten rear arm mounting cap screws to 35
ft. Ibs. torque, using a 9/16-inch socket and
torque wrench.
Fig. VII-116
)