Arctic Cat Panther 1974 Manual page 229

BODY SERVICING
Fig. VII-112
~
WARNING
~
Make sure the taillight wires do not bind or get
pinched between the fuel tank and rear shroud.
If the wires get pinched, a short circuit . may
develop and cause a lighting malfunction. A
no-light condition during limited visibility
could contribute to an accident.
3. Set the assembled fuel tank and rear shroud in
position on the tunnel, Fig. VII-111.
4. Slide the two red taillight wire end pieces into
a connector, Fig. V 11-113.
5. Slide the two black taillight wire end pieces
into a connector, Fig. VII-113.
Fig. VII -1 13
6. Align the holes in the rear bumper (near
passenger handle grips) and tunnel. Secure
sides of rear bumper to tunnel with four
machine screws and nylon cap nuts, Fig.
VII-111, using a 7/16-inch blade.
III
Note: Nylon cap nuts are to be positioned on
the outside of the rear bumper.
7.
II
8.
Secure the end plate, snow flap and back of
rear bumper to end of tunnel with four
machine screws and nylon cap nuts, Fig.
VII-111, using a 7/16-inch blade_
Note: Nylon cap nuts are to be positioned on
the outside of the rear bumper.
Lower the rear of the snowmobile and remove
the Quik Jack.
9. Connect the taillight connector that holds
two red wires to the taillight harness red wire
connector, Fig. V" -114.
10. Connect the taillight connector that holds
two black wires to the taillight harness black
wire connector, Fig. V" -114.
Fig. VII -114
VII-37