Arctic Cat Panther 1974 Manual page 205

c
(
STEERING SERVICING
Fig. VII43
11. Remove the two cap screws and lock nuts
that hold steering post clamp and bracket to
the steering tower, Fig. VII-44, using a
7/16-inch socket and wrench. Set steering
post clamp aside.
Fig. VI144
12. If only the tie rod ends are to be replaced,
proceed to step 13. If the complete steering
post is to be replaced, proceed to step 14.
13. Pivot steering post toward drive clutch.
Remove the cap screw and lock nut that holds
tie rod end to the bottom of the steering post,
Fig. VII-45, using a 9/16-inch socket and
wrench .
Fig. VII -45
14. Loosen the set screw, Fig. VII-46, that holds
brake handle to handlebar, using a 1/8-inch
allen wrench. Pull brake handle off handlebar.
Fig. VI146
Set'- /
Screw
15. Drive spring pin, Fig. VII-47, out of throttle
handle and handlebar,
using a 5/16 x 1/8-inch
flat end punch and hammer. Loosen set
screw, Fig. VII-47, using 1/8-inch allen
wrench. Pull throttle handle off handlebar.
Fig. VI147
Spring Pin
VII-13