Install Lower Shroud (Toolbox) - Arctic Cat Panther 1974 Manual

BODY SERVICIN G
5. Loosen the three-Quarter-turn studs that hold
lower shroud to brackets on steering support
tower, left side of tunnel and right side of
tunnel, Fig. VII -90, using a screwdriver having
a 7/ 16-i nch blade.
Fig. VII-90
6. Slide the lower shroud away from the steering
post.
7. Drill out the pop rivets that hold toolbox
bottom to lower shroud, using a 5/ 32-inch bit
and air-powered drill.
II Note: The toolbox pad is to be considered as
a separate part if the lower shroud is being
replaced.
Install Lower Shroud (Toolbox)
Equipment Necessary: Air-Operated Pop Rivet
Tool, Screwdriver Having a 7/16-lnch Blade and
7/16-lnch Wrench
1. Assemble the toolbox bottom and lower
shroud with pop rivets and washers, using an
air-operated pop rivet tool.
VII -28
2. Install toolbox pad on toolbox bottom.
3. Slide lower shroud into position against the
steering support tower. Secure the lower
shroud in place with three-Quarter-turn studs,
washers and receptacles, Fig. VII-91, using a
screwdriver having a 7/16-inch blade.
Fig. VII·91
4. Install the seat on the tunnel, Fig. VII-92.
)
)