Arctic Cat Panther 1974 Manual page 179

SKID FRAME DISASSEMBL V
r _
Note: If skid frame is damaged and
- replacement is necessary, remove the 2
idler wheel adjusting bolts, hex nuts, lockwashers
and square nuts.
2. Remove capscrew and flat washer, Fig. VI-18,
that secures idler wheel to idler wheel axle,
using a 1/2-inch socket. Repeat this step on
opposite side.
Fig. VI·18
.3. Slide rear idler wheel and large flat washer off
axle, Fig. VI-19.
Fig. VI·19
II Note: It may be necessary to tap lightly near
center hub before rear idler wheel will slide
off axle.
4. Remove drive pin from axle, using a hammer
and 5/16 x 1/8-inch punch, Fig. VI-20.
Fig. VI·20
5.
Remove set screw from spacer, using a
3/16-
inch Allen wrench, Fig. VI-21. Remove set
screw from opposite side spacer.
Fig. VI·21
6.
Drive out rear axle, using a 1/2-inch
nonferous dowel and hammer, Fig. VI-22.
Fig. VI·22
VI·7