Arctic Cat Panther 1974 Manual page 168

TRACK DRIVE INSTALLATION
2. Check Sprocket Alignment - Lay a twelve
inch straight edge on face of top and bottom
sprocket, Fig. V-112. No visible gap is to be
evident between straight edge contact surface
and sprocket face. If al ignment is correct,
proceed to step 3. I f there is a gap between
straight edge contact su rface and sprocket
face, an adjustment is necessary (see Sprocket
Alignment Adjustment, page V-43).
Fig. V-112
3. Push against capscrew w/grease fitting until
chain tightens. Chain is to have approximately
1/4-inch deflection at midspan, when
squeezed together using thumb and
forefinger, Fig. V -113.
V-52
Fig. V-113
4. When proper adjustment is obtained, tighten
capscrew with grease fitting and any
remaining lock capscrew(s), Fig. V-114, using
a 9/16-inch socket. Recheck chain tension
and adjust if necessary.
Fig. V-l14
)