Arctic Cat Panther 1974 Manual page 183

(
c
l
51<10 FRAME ASSEMBLY
6. Install drive pin, Fig. VI-26, in each end of
idler wheel axle, using a hammer. Drive pin is
to extend equally on both sides of axle.
Fig. VI·26
7. Place a large flat washer on the idler wheel
axle, Fig. VI-26.
8.
Hold rear idler wheel in position and secure to
axle with capscrew and flat washer, Fig.
VI -27, using . a 1/2-inch socket. Tighten
capscrew to 14 - 19 ft. Ibs. torque, using a
torque wrench.
Fig. VI-27
II
Note: Largest diameter recess at center of
idler wheel is to fit against the large flat
washer that contacts the drive pin, Fig. VI-26.
9. Repeat steps 7 and 8 on opposite side of idler
wheel axle.
Install Rear Arm
Equipment Necessary: 5/8-lnch Short Socket,
5/8-lnch Wrench, 9/16-lnch Deep-Well Socket,
9/16-lnch Open End Wrench, Torque Wrench,
Grease Gun and Low-Temperature Grease (Texaco
2346EP or Equivalent)
1. I nstall stationary end of shock absorber
between the skid frame cross member mount
and secure in place with capscrew and
locknut, Fig. VI-28, using a 5/8-inch short
socket and wrench. Tighten locknut to 45 -
55 ft. Ibs. torque, using a 5/8 -inch short
socket and torque wrench.
Fig. VI·28
2. I nstall rear arm slides into rear arm and insert
bushing into both rear arm slide pivot points,
Fig. VI-29.
Fig. VI·29
VI-11