Arctic Cat Panther 1974 Manual page 82

FUEL TANK SERVICING
9.
Lower the rear of the snowmobile to the floor
and remove the Quik Jack.
10. Connect the red taillight wire connector block
to the red wire connector block (main
harness), Fig. 111 -41.
11. Connect the black taillight wire connector
block to the black wire connector block
(main harness), Fig. 111 -41.
Fig. 111·41
12. Insert the fitting and fuel line with fuel filter
into the fuel tank. Make sure the rubber
around the fitting seats in the mounting hole,
Fig. 111-42.
13. Insert the vapor return line with fitting into
the fuel tank. Make sure the rubber around
the fitting seats in the mounting hole, Fig.
111-42.
14. I nstall the fuel level gauge cap, Fig. 111-42.
Fig. 111-42
111-24
15. Tip the snowmobile onto its side and allow to
rest on a piece of cardboard to protect against
scratching.
16. Align the hole in the skid frame rear axle with
the body tunnel mounting hole and secure in
place with a lockwasher and cap screw, using
a 9/16-inch socket and 3-inch extension.
17. Tip snowmobile onto the opposite side and
allow to rest on a piece of cardboard to
protect against scratching. Repeat step 16 on
the rear axle. Tighten the cap screws to 35 ft.
Ibs. torque, using a torque wrench.
18. Set the snowmobile upright and install the
seat cushion and backrest.
19. Suspend the rear of the snowmobile up on a
Quik Jack.
20. Secure the rear bumper to the wear plate at
the end of the running board with 3 pop
rivets, using a pop rivet tool, Fig. 111-43.
Perform this step on opposite side.
Fig. 111-43
21. Lower the rear of the snowmobile to the floor
and remove the Quik Jack.
22. Check the track tension (see Section V -
Drive System, Track Tension).
23. Check the track alignment (see Section V -
Drive System, Track Alignment).