Arctic Cat Panther 1974 Manual page 225

c
r
c
BODY SERVICING
Install Vinyl Strip, Reflectorized Strip and
Reflector
Equipment Necessary: Pliers, Screwdriver Having a
1/4-lnch Blade and Phillips Screwdriver Having a
No.3 Blade
1. Apply liquid detergent on backside of vinyl
strip. I nsert end of vinyl strip into track in
bumper, Fig. VII-101. Grasp end of vinyl strip
and pull completely around bumper, using a
pliers.
Fig. VII-101
2. Secure the vinyl strip to the bumper with two
metal screws, using a screwdriver having a
1/4-inch blade.
3. Apply liquid detergent on backside of
reflectorized strip. I nsert end of reflectorized
strip into track in vinyl strip, Fig. VII-102.
Grasp end of reflectorized strip and pull
completely around the vinyl strip, using a
pliers.
Fig. VII-102
4. I nsert screwdriver blade between end of
bumper and belly pan. Pry bumper away from
belly pan and slide reflector housing into
bumper track, Fig. VII-103.
II
Note: The bumper must be pried away from
the belly pan so that clearance can be
obtained between the lapped-side of the footrest
and the end of the reflector housing. If bumper is
not pried away from belly pan, there will not be
enough clearance to allow the reflector housing to
slide the lapped-side of the footrest.
Fig. VII-103
5. I nstall the metal screw that holds the reflector
housing to the bumper, Fig. VII-104, using a
screwdriver having a 114-i nch blade.
6. I nstall mach ine screw that holds end of
bumper to footrest, Fig. VII-104, using a
phillips screwdriver having a no. 3 blade.
Fig. VII-104
7. Snap the reflector into the reflector housing.
VII-33