Parameter List (By Parameter Number) - Mitsubishi Electric 800 Series Instruction Manual (Function

3.2

Parameter list (by parameter number)

For simple variable-speed operation of the inverter, the initial values of the parameters may be used as they are. Set the
necessary parameters to meet the load and operational specifications. Parameter's setting, change and check can be made
on the operation panel.
NOTE
• Simple Simple Simple indicates simple mode parameters. Use Pr.160 User group read selection to indicate the simple mode parameters
only (initial setting is to indicate the extended mode parameters).
• The changing of the parameter settings may be restricted in some operating statuses. Use Pr.77 Parameter write selection
to change the setting of the restriction.
• Refer to page 508
Parameter copy, Parameter clear, and All parameter clear.
Notation
[E800]: Available for the standard model.
[E800-1]: Available for the FM type inverter (standard model).
[E800-4]: Available for the AM (50 Hz) type inverter (standard model).
[E800-5]: Available for the AM (60 Hz) type inverter (standard model).
[E800(-E)]: Available for the standard and Ethernet models.
[E800-(SC)E]: Available for the Ethernet model and the safety communication model.
[E800-SCE]: Available for the safety communication model.
[E800-(SC)EPA]: Available for the Protocol group A (Ethernet model / safety communication model).
[E800-(SC)EPB]: Available for the Protocol group B (Ethernet model / safety communication model).
[200/400 V class]: Available for the 200/400 V class inverters.
[575 V class]: Available for the 575 V class inverters.
[3-phase]: Available for the three-phase power input model.
for instruction codes for communication, parameters under different control methods, and availability of
3. Parameters
3.2 Parameter list (by parameter number)
1
2
3
4
5
6
7
8
9
10
55