Parameter List (By Parameter Number) - Mitsubishi Electric 800 Series Instruction Manual

3.2

Parameter list (by parameter number)

For simple variable-speed operation of the inverter, the initial values of the parameters may be used as they are. Set the
necessary parameters to meet the load and operational specifications. Parameter's setting, change and check can be made
on the operation panel.
NOTE
• Simple Simple Simple indicates simple mode parameters. Use Pr.160 User group read selection to indicate the simple mode parameters
only (initial setting is to indicate the extended mode parameters).
• The changing of the parameter settings may be restricted in some operating statuses. Use Pr.77 Parameter write selection
to change the setting of the restriction.
• Refer to page 416
Notation
[E800]: Available for the standard model.
[E800-1]: Available for the FM type inverter (standard model).
[E800-4]: Available for the AM (50 Hz) type inverter (standard model).
[E800-5]: Available for the AM (60 Hz) type inverter (standard model).
[E800-(SC)E]: Available for the Ethernet model and the safety communication model.
[E800-SCE]: Available for the safety communication model.
[E800-(SC)EPA]: Available for the Protocol group A (Ethernet model / safety communication model).
[E800-(SC)EPB]: Available for the Protocol group B (Ethernet model / safety communication model).
[200/400 V class]: Available for the 200/400 V class inverters.
[575 V class]: Available for the 575 V class inverters.
[3-phase]: Available for the three-phase power input model.
 Pr.0 to Pr.99
Pr.
Function Pr.
group
0 G000
1 H400
2 H401
3 G001
4 D301
5 D302
6 D303
7 F010
8 F011
H000
9
C103
for instruction codes for communication and availability of parameter copy, Parameter clear, and all clear.
Name
Torque boost Simple Simple Simple
Maximum frequency Simple Simple Simple
Minimum frequency Simple Simple Simple
Base frequency Simple Simple Simple
Multi-speed setting (high
speed) Simple Simple Simple
Multi-speed setting (middle
speed) Simple Simple Simple
Multi-speed setting (low
speed) Simple Simple Simple
Acceleration time Simple Simple Simple
Deceleration time Simple Simple Simple
Electronic thermal O/L
relay
Simple Simple Simple
Rated motor current Simple Simple Simple
Minimum
Setting range setting
increments
0% to 30% 0.1%
0 to 120 Hz 0.01 Hz
0 to 120 Hz 0.01 Hz
0 to 590 Hz 0.01 Hz
0 to 590 Hz 0.01 Hz
0 to 590 Hz 0.01 Hz
0 to 590 Hz 0.01 Hz
0 to 3600 s 0.1 s
0 to 3600 s 0.1 s
0 to 500 A 0.01 A
3.2 Parameter list (by parameter number)
Initial
Refer Customer
*1
value
to page setting
Gr.1 Gr.2
*2
6%
*2
5%
*2
384
4%
*2
3%
*2
2%
120 Hz 219
0 Hz 219
60 Hz 50 Hz 386
60 Hz 50 Hz 202
30 Hz 202
10 Hz 202
*3
5 s
164
10 s
*3
5 s
164
10 s
206,
Inverter rated
309,
current
318
3. Parameters
1
2
3
4
5
6
7
8
9
10
51