Parameter List (By Parameter Number) - Mitsubishi Electric 800 Series Instruction Manual

3
Parameters
This chapter explains the function setting for use of this product.
Always read the instructions before use.
The following marks are used to indicate the controls. (Parameters without any mark are valid for all the controls.)
Mark
V/F V/F V/F
Magnetic flux Magnetic flux Magnetic flux
Sensorless Sensorless Sensorless
PM PM PM
3.1

Parameter list (by parameter number)

For simple variable-speed operation of the inverter, the initial values of the parameters may be used as they are. Set the
necessary parameters to meet the load and operational specifications. Parameter's setting, change and check can be made
on the operation panel.
NOTE
• Simple Simple Simple
only (initial setting is to indicate the extended mode parameters).
• The changing of the parameter settings may be restricted in some operating statuses. Use Pr.77 Parameter write selection
to change the setting of the restriction.
• Refer to
Notation
[E800]: Available for the standard model.
[E800-1]: Available for the FM type inverter (standard model).
[E800-4]: Available for the AM (50 Hz) type inverter (standard model).
[E800-5]: Available for the AM (60 Hz) type inverter (standard model).
[E800-E]: Available for the Ethernet model.
[E800-EPA]: Available for the Protocol group A (Ethernet model).
[E800-EPB]: Available for the Protocol group B (Ethernet model).
[200/400 V class]: Available for the 200/400 V class.
[575 V class]: Available for the 575 V class inverters.
50
3. Parameters

3.1 Parameter list (by parameter number)

V/F control
Advanced magnetic flux vector control
Real sensorless vector control
PM sensorless vector control
indicates simple mode parameters. Use Pr.160 User group read selection to indicate the simple mode parameters
page 406 for instruction codes for communication and availability of Parameter clear, all clear, and Parameter copy.
Control method Applied motor
Three-phase induction motor
PM motor