Snmp Traps; Ups Mib - Eaton Network-M2 User Manual

7.5.6.2.3 Alarms
Code Severity
1302 Info

7.6 SNMP traps

7.6.1 UPS Mib

7.6.1.1 IETF Mib-2 Ups traps
This information is for reference only.
Trap oid :
.1.3.6.1.2.1.33.2.0.x
.1.3.6.1.2.1.33.2.0.1
.1.3.6.1.2.1.33.2.0.3
.1.3.6.1.2.1.33.2.0.4
Alarm oid at :
.1.3.6.1.2.1.33.1.6.3.x
.1.3.6.1.2.1.33.1.6.3.1
.1.3.6.1.2.1.33.1.6.3.2
.1.3.6.1.2.1.33.1.6.3.3
.1.3.6.1.2.1.33.1.6.3.5
.1.3.6.1.2.1.33.1.6.3.6
.1.3.6.1.2.1.33.1.6.3.8
.1.3.6.1.2.1.33.1.6.3.9
.1.3.6.1.2.1.33.1.6.3.10
.1.3.6.1.2.1.33.1.6.3.13
.1.3.6.1.2.1.33.1.6.3.14
.1.3.6.1.2.1.33.1.6.3.16
.1.3.6.1.2.1.33.1.6.3.17
.1.3.6.1.2.1.33.1.6.3.18
Active message
Alarms: the number of alarms is
high and above 5 000
Description :
Sent whenever the UPS transfers on battery,
then sent every minutes until the UPS Comes back to AC Input.
Sent whenever an alarm appears.
The matching alarm oid is added as bound variables in the table below.
Sent whenever an alarm disappears.
The matching alarm oid is added as bound variables in the table below.
Description when trap 3
Battery test failed
Battery discharging
Low battery
Temperature alarm
Input AC not present
Power overload
Bypass mode
Bypass not available
Battery charger fault
Not powered
Fan fault
Battery fuse fault
Rectifier fuse fault
Inverter fuse fault
Internal failure
Non-active message
Alarms: the number of alarms is
back to normal
Description when trap 4
Battery test OK
End of UPS battery discharge
Battery OK
Temperature OK
Input AC present
No power overload
No more on bypass
Bypass available
Battery charger OK
Powered (Protected or Not protected)
Fan OK
Battery fuse OK
Rectifier fuse OK
Inverter fuse OK
End of internal failure
SNMP traps
Advice
It is recommended to
Export and Clear the alarm
log.
Information – 239