Eaton Network-M2 User Manual page 216

Default settings and possible parameters
Default settings and possible parameters - Network & Protocol
IPV4
IPV6
DNS/DHCP
Ethernet
HTTPS
Syslog
Information – 216
Default setting
Mode — DHCP
Enable — checked
Mode — DHCP
Hostname — device -[MAC address]
Mode — DHCP
Configuration — Auto negotiation
Port — 443
Inactive
• Server#1
Name – Primary
Status – Disabled
Hostname – empty
Port – 514
Protocol – UDP
Message transfer method – Non transparent framing
Using unicode byte order mask (BOM) – disabled
• Server#2
Name – empty
Status – Disabled
Hostname – empty
Port – 514
Protocol – UDP
Message transfer method – DIsabled in UDP
Using unicode byte order mask (BOM) – disabled
Possible parameters
Mode — DHCP/Manual (Address/Netmask/Gateway)
Enabled — Active/Inactive
Mode — DHCP/Manual (Address/Prefix/Gateway)
Hostname — 128 characters maximum
Mode :DHCP/Manual (Domain name/Primary DNS/
Secondary DNS)
Configuration — Auto negotiation - 10Mbps - Half
duplex - 10Mbps - Full duplex - 100Mbps - Half duplex
- 100Mbps - Full duplex - 1.0 Gbps - Full duplex
Port — x-xxx
Inactive/Active
• Server#1
Name – 128 characters maximum
Status – Disabled/Enabled
Hostname – 128 characters maximum
Port – x-xxx
Protocol – UDP/TCP
Message transfer method – Non transparent framing
Using unicode byte order mask (BOM) – disable/
enable
• Server#2
Name – 128 characters maximum
Status – Disabled/Enabled
Hostname – 128 characters maximum
Port – x-xxx
Protocol – UDP/TCP
Message transfer method (in TCP) – Octet counting/
Non transparent framing