Ats Alarm Log Codes - Eaton Network-M2 User Manual

7.5.4 ATS alarm log codes

To retrieve Alarm logs, navigate to
Below codes are the one to be used to add "Exceptions on events notification" on email sending configurations.
Some zeros maybe added in front of the code when displayed in emails or logs.
7.5.4.1 Critical
Code Severity
F03 Critical
F08 Critical
F0B Critical
F0D Critical
F10 Critical
F11 Critical
F13 Critical
F1B Critical
7.5.4.2 Warning
Code Severity
F00 Warning
F01 Warning
F02 Warning
F04 Warning
F06 Warning
F07 Warning
F09 Warning
F0C Warning
F0F Warning
F12 Warning
F15 Warning
F16 Warning
F17 Warning
F18 Warning
F1A Warning
Contextual help>>>Alarms
Active message
Internal failure
Internal failure
Internal failure
In short circuit
Load not powered
Internal failure
Temperature out of range
Off
Active message
Unsynchronized sources
Frequency out of range
Out of range
Voltage in derated range
Frequency out of range
Not in range
Voltage in derated range
In overload
Internal configuration failure
Overload Fault
Input waveform is not OK
Voltage out of range
Input waveform is not OK
Voltage out of range
On alternate source
section and press the Download alarms button.
Non-active message
End of internal failure
End of internal failure
End of internal failure
Not in short circuit
Load powered with no continuity
End of internal failure
Temperature in range
On preferred source
Non-active message
Synchronized sources
Frequency in range
In range
Voltage in normal range
Frequency in range
In range
Voltage in normal range
Not in overload
Internal configuration OK
No overload fault
Input waveform is OK
Voltage in range
Input waveform is OK
Voltage in range
-
List of event codes
Advice
-
-
-
-
-
-
-
-
Advice
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Information – 235