Cabling The First Emp To The Device - Eaton Network-M2 User Manual

Installing the EMP

6.3.3 Cabling the first EMP to the device

6.3.3.1 Available Devices
6.3.3.1.1 Network-M2/INDGW
Network-M2
6.3.3.2 Connecting the EMP to the device
Address must be defined before the EMP power-up otherwise the changes won't be taken into account.
Do not set Modbus address to 0, otherwise the EMP will not be detected.
6.3.3.2.1 Material needed:
• EMP
• RJ45 female/female connector (supplied in EMP accessories)
• USB to RS485 converter cable (supplied in EMP accessories)
• Ethernet cable (not supplied).
• Device
6.3.3.2.2 Connection steps
STEP 1 – Connect the "USB to RS485 converter cable" to the USB port of the Device.
Servicing the EMP – 206
INDGW