Eaton Network-M2 User Manual page 106

Settings
Press Save after modifications.
2- Configure the syslog server:
• Click the edit icon
• Enter or change the server name.
• Select Yes in the Active drop-down list to activate the server.
• Enter the Hostname and Port.
• Select the Protocol – UDP/TCP.
• In TCP, select the message transfer method – Octet counting/Non-transparent framing.
• Select the option Using Unicode BOM if needed.
• Press Save after modifications.
3.7.4.3 Default settings and possible parameters - Network & Protocol
IPV4
IPV6
DNS/DHCP
Ethernet
Contextual help of the web interface – 106
to access settings.
Default setting
Mode — DHCP
Enable — checked
Mode — DHCP
Hostname — device -[MAC address]
Mode — DHCP
Configuration — Auto negotiation
Possible parameters
Mode — DHCP/Manual (Address/Netmask/Gateway)
Enabled — Active/Inactive
Mode — DHCP/Manual (Address/Prefix/Gateway)
Hostname — 128 characters maximum
Mode :DHCP/Manual (Domain name/Primary DNS/
Secondary DNS)
Configuration — Auto negotiation - 10Mbps - Half duplex
- 10Mbps - Full duplex - 100Mbps - Half duplex -
100Mbps - Full duplex - 1.0 Gbps - Full duplex