Changing The Rtc Battery Cell - Eaton Network-M2 User Manual

STARTING UPDATE FROM: [FW_Update.tar] to [X.X.X.X]
Transfer by scp (FW_Update.tar) to [X.X.X.X]
Warning: Permanently added
Transfer done.
Check running upgrade status ...
Check firmware binary signature
Uncompress and flash upgrade
Uncompress and flash upgrade
Uncompress and flash upgrade
Uncompress and flash upgrade
Uncompress and flash upgrade
Uncompress and flash upgrade
Uncompress and flash upgrade
Uncompress and flash upgrade
Uncompress and flash upgrade
Executing post post_upgrade.sh script upgrade
Upgrade done
Warning: Permanently added
Rebooting...
res: Y
Update: OK

4.7 Changing the RTC battery cell

1. Access the Network Module, and then disconnect the Network cable, if needed.
2. Unscrew the Network Module and remove it from the slot.
3. Locate the RTC battery cell located on the back of the Network Module.
4. Get a new battery cell (CR1220 type).
'X.X.X.X' (ECDSA) to the list of known hosts.
- inProgress(%):11
- inProgress(%):28
- inProgress(%):44
- inProgress(%):61
- inProgress(%):78
- inProgress(%):92
- inProgress(%):100
- inProgress(%):100
'X.X.X.X' (ECDSA) to the list of known hosts.
Changing the RTC battery cell
Servicing the Network Management Module – 171