Eaton Network-M2 User Manual page 119

This section is only for the Modbus Network ModuleINDGW
For instructions on connecting Modbus RTU see the
Module>>>Wiring the RS-485 Modbus RTU terminal>>>Configuring the
For instructions on configuring Modbus see the section
Installing the Network Management Module>>>Configuring Modbus
.
3.7.6.1 Modbus RTU
The following Modbus RTU settings are configurable:
• Enable
• Baud rate
• Parity
• Stop bits
3.7.6.2 Modbus TCP
The following Modbus TCP settings are configurable:
• Enable
• Port
section Installing the Network Management
termination.
Contextual help of the web interface – 119
Settings