Eaton Network-M2 User Manual page 231

816 Warning
817 Warning
818 Warning
819 Warning
81A Warning
81B Warning
81D Warning
900 Warning
901 Warning
B01 Warning
7.5.2.3 Info
Code Severity
005 Info
009 Info
013 Info
101 Info
102 Info
603 Info
63C Info
A00 Info
A01 Info
A0F Info
7.5.2.4 Good
Alarms with a severity set as Good are not taken into account into the counter of active alarms.
Code
60E
826
Compatibility failure
Output over current
Output frequency out of range
Output voltage too high
Output voltage too low
UPS Shutoff requested
Load not powered
Maintenance bypass
Maintenance bypass breaker
closed
Batteries are aging. Consider
replacement
Active message
Communication lost (with UPS)
On high efficiency / On ESS mode High efficiency disabled / ESS
Upgrading: limited communication End of upgrade mode
On AVR (Boost)
On AVR (Buck)
Battery discharging
Battery information
Group 1 is OFF
Group 2 is OFF
Group is OFF
Severity
Good
Good
Compatibility OK
No output over current
Output frequency in range
Output voltage OK
Output voltage OK
End of UPS shutoff requested
Load protected
Not on maintenance bypass
Maintenance bypass breaker open
Batteries aging condition cleared
Non-active message
Communication recovered (with
UPS)
disabled
End of AVR (Boost)
End of AVR (Buck)
End of UPS battery discharge
Battery OK
Group 1 is ON
Group 2 is ON
Group is ON
Active message
UPS external battery set as "No battery"
Load powered
List of event codes
Service required
Reduce output load
Service required
Service required
Service required
Service required
-
-
-
-
Advice
Service required
-
-
-
-
-
-
-
-
-
Information – 231