Restoring Default Settings; Chapter 15 Others; Configuring General Settings - HIKVISION EKI-K82T46 User Manual

3. Enter the FTP Server Address in the text field.
4. Click the Upgrade button to start upgrading.
5. After the upgrading is complete, reboot the NVR to activate the new firmware.
14.6

Restoring Default Settings

1. Enter the Default interface, Menu > Maintenance > Default.
2. Select the restoring type from the following three options.
Restore Defaults: Restore all parameters, except the network (including IP address, subnet mask,
•
gateway, MTU, NIC working mode, default route, server port, etc.) and user account parameters, to
the factory default settings.
Factory Defaults: Restore all parameters to the factory default settings.
•
Restore to Inactive: Restore the device to the inactive status.
•
3. Click the OK button to restore the default settings.
NOTE: The device will reboot automatically after restoring to the default settings.

Chapter 15 Others

15.1

Configuring General Settings

Purpose
You can configure the BNC output standard, VGA output resolution, mouse pointer speed through the
Menu > Configuration > General interface.
NVR User Manual 061220NA
Figure 239, FTP Upgrade Interface
Figure 240, Restore Defaults
155