HIKVISION EKI-K82T46 User Manual page 165

− Input mode of the monitor is incorrect.
1. Verify the device is connected with the monitor via HDMI or VGA cable.
2. If not, please connect the device with the monitor and reboot.
3. Verify the connection cable is good.
4. If there is still no image display on the monitor after rebooting, please check if the connection cable is
good, and change a cable to connect again.
5. Verify Input mode of the monitor is correct.
6. Check the input mode of the monitor matches with the output mode of the device (e.g. if the output
mode of NVR is HDMI output, then the input mode of monitor must be the HDMI input).If not, modify the
monitor's input mode.
7. Check if the fault is solved by steps 1 to 3.
8. If it is solved, finish the process. If not, contact an engineer from Hikvision for further processing.
There is an audible warning sound "Di-Di-Di-DiDi" after a new bought NVR starts up.
•
Possible Reasons:
No HDD is installed in the device.
•
The installed HDD has not been initialized.
•
The installed HDD is not compatible with the NVR or is defective.
•
1. Verify at least one HDD is installed in the NVR, if not, install a compatible HDD.
NOTE: Refer to the "Quick Operation Guide" for the HDD installation steps.
2. If you don't want to install a HDD, select "Menu > Configuration > Exceptions," and uncheck the "HDD
Error" Audible Warning checkbox.
3. Verify the HDD is initialized.
1) Select "Menu > HDD > General."
2) If the status of the HDD is "Uninitialized," check the checkbox of corresponding HDD and click the
"Init" button.
4. Verify the HDD is detected and is in good condition.
1) Select "Menu > HDD > General."
2) If the HDD is not detected or the status is "Abnormal," replace the dedicated HDD according to the
requirement.
5. Check if the fault is solved by steps 1 to 3.
NVR User Manual 061220NA 165