Calling Linear Scan; One-Touch Park - HIKVISION EKI-K82T46 User Manual

NOTE: The speed dome starts linear scan from the left limit to the right limit, and you must set
the left limit to the left side of the right limit, as well the angle from the left limit to the
right limit should be no more than 180º.
4.2.8 Calling Linear Scan
Before operating this function, make sure the connected camera supports linear scan
NOTE:
and is in HIKVISION protocol.
Purpose
Follow the procedure to call the linear scan in the predefined scan range.
1. Click the PTZ button in the lower-right corner of the
the front panel, or click the
in live view mode.
2. Click the button to show the one-touch function of the
3. Click the Linear Scan button to start the linear scan, and click the Linear Scan button again to stop it.
You can click the Restore button to clear the defined left limit and right limit data and the dome needs to
reboot to make settings take effect.
4.2.9

One-Touch Park

NOTE: Before operating this function, make sure the connected camera supports
and is in HIKVISION protocol.
Purpose
Certain models of speed dome can be configured to start a predefined park action (scan, preset, patrol,
etc.) automatically after a period of inactivity (park time).
1. Click the PTZ button in the lower-right corner of the
the front panel, or click the
in live view mode.
2. Click the button to show the one-touch function of the
NVR User Manual 061220NA
PTZ Control icon in the quick setting bar to enter the
Figure 65, PTZ Panel−One-Touch
PTZ Control icon in the quick setting bar to enter the
PTZ setting interface, or press the
PTZ control.
PTZ setting interface, or press the
PTZ control.
PTZ button on
PTZ setting menu
linear scan
PTZ button on
PTZ setting menu
55